We only need to remove the pin pictured above, which is easily accomplished with a pair of needle nosed pliers. Either way, they are the same thing.) On this particular slot machine, the shaft is held by hairpins. (Regional note: I’ve noticed that people in the South tend to use the term “cotter pin” while folks in the Midwest and Northeast tend to say “cotter key”. This is a pretty simple matter, although the shaft is sometimes difficult to remove due to the accumulation of dirt and hardened oil/grease.ĭepending on the machine, this shaft is usually held in place by two hairpins or cotter pins. Now we need to remove the levers themselves by removing the shaft at the bottom of the levers. Generally it is a good idea to slip the spring off of the ear and leave it connected to the part where it is threaded through a hole.Īfter the springs are disconnected from the back bracket, you can lay the reel stop levers down as shown above. As with most springs in the machine, one end will be threaded through a hole and the other end will be looped around some sort of post or ear. The springs are easy to find… they are the long springs attached to each of the reel stop levers that connect them to the back of the mechanism. The first step is to disconnect the reel stop lever springs. We need to get the levers out of the way, then remove them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |